Firmware upgrade

[Marian]

Gents,

do excuse my ignorance, but how do you load the bin file on 9100A ?

Thank you !

[mycal]

..Warning Updating Firmware is strictly at your own risk..

You must first download the firmware, there is a link on this page
http://www.yoics.com/?p=28

Then if you are using the stock AVIOSYS 9100a you must use Internet Explorer to upgrade firmware. Most Yoics versions support both IE and Firefox, but not the original AVIOSYS software.

Using IE connect to the 9100 via its web interface.

Select configuration on the left hand side.

Then select System on the left hand side.

Scroll down on the right hand side and select firmware upgrade.

Hit the browse button and select the .bin file you downloaded above and select upload.

Click [here] to begin firmware upgrade.

click [ok] again

The progress bar should start moving across.

Wait for upgrade to complete, do not power off 9100a unit or you may damage the upgrade image.

then when done [click here to reboot IP video]

Wait for reboot timer to tick down.

You should now be looking at your new firmware.

[mike77]

Hi!

Is it also possible to use the firmware for the new Aviosys 9100B in metal case?

Is inside of the case the same like 9100A?

Has anybody tested the Yoics firmware with the 9100B?

Thanks in advance,

Mike77

[mycal]

I haven't done it myself, but I think there was some discussion on the yahoo board about it.

http://tech.groups.yahoo.com/group/9100/

-M